Multi Blanking Line Types of material:
Carbon Steel, stainless steel, aluminium, non ferrous metals and
alloys.
Cold rolled, hot rolled, pickled, galvanized, dried, oiled, any
coating and metals with sensitive surfaces.
As the coil build up, the recoiler rpm correspondingly goes down to
keep desired constant line speed. This process goes on until the
end of coil on uncoiler. The slitted coil is pushed on the exit
coil car through a pusher plate operated by hydraulic cylinder. The
side slitted scrap is wound on the scrap winder units provided on
both sides of the slitter.
Main Technical Parameters of Multi Blanking Line
1. Coil properties: δs≤550MPa, δb≤600MPa
2. Coil thickness: 3mm-12mm
3. Coil width: Max. 2200mm
4. Coil I.D: 508 mm
5. Coil O.D: Max. 1800 mm
6. Coil weight: 30000 kg
7. Line speed: 0-30 m/min
8. Leveler shaft diameter: 180 mm
9. Leveler rollers quantity: 11
10. Cutting length: 800-12000 mm
11. Cutting rate: 12 pieces/min
12. Length tolerance: ±1 mm
13. Diagonal tolerance: ±2 mm
14. Straightening tolerance: ±2 mm/m2
15. Total power: about 200 KW
16. Total weight: about 70 T
The lines can be supplied with start-stop shears, flying shears or
continuous direct feed. Edge trimming may be incorporated.
Multi Blanking Line working process:
Steel coils are transferred by an entry coil car and loaded onto an
uncoiler. From uncoiler the strip proceeds through a five-high
precision leveler designed to level steel within the desired
material gauge range and yield strength. The strip then proceeds
through a squaring unit and precision roll-feed unit to the high
speed shear, where it is cut to required length. The cut sheet then
moves to float sheet stacker where it is stacked on a pallet and is
then moved onto the semiautomatic packaging line for wrapping.
Benefits of Multi Blanking Line
- Minimal tooling preparations and higher productivity rates
- Energy efficient
- Reduced operating costs
- High in speed and strength
- High input and output rates
- Extreme sheet flatness due to high precision levelers
- Exact cutting accuracy
Multi Blanking Line Parameter
| Type | RS6×2000 | RS8×2000 | RS10×2200 | RS2×2200 | RS16×2200 |
Thickness Range (mm) | 1-6 | 2-8 | 2-10 | 3-12 | 4-16 |
Width Range (mm) | 2000 | 2000 | 2200 | 2200 | 2200 |
Cutting Length (mm) | 500-6000 | 600-8000 | 600-10000 | 800-12000 | 800-12000 |
Cutting Precision (mm) | ±0.5 | ±1 | ±1 | ±1 | ±1 |
| Roller Numbers | 15 | 13 | 13 | 11 | 11 |
| Roller Diameter | Ф140 | Ф155 | Ф160 | Ф180 | Ф200 |
Coil ID Linear Speed |
Ф508&610mm 0~28m/min or 0-60m/min |
Ф&610&760mm 0~28m/min or 0-60m/min |
Ф610&760mm 0~28m/min
| Ф610&760mm 0~28m/min | Ф610&760mm 0~28m/min |
